how to clean mass air flow sensor 2011 nissan altima

Symptoms

This is a list of common symptoms you will notice when your Nissan MAF sensor fasensor fails.

Hinderance engine lightengine light happening
Nissan is hard to part with.
Engine stalls before long later starting
The engine runs unusually lean or rich, idling.
Vehicle idles to high or rock-bottom.
Nissan hesitates when under load.
The vehicle hesitates and jerks during acceleration.
High fuel consumption, underprivileged MPG.

How to Diagnose Nissan MAF Sensor PrSensor Problems

To diagnose the Nissan MAF detector, you will need to read the fault codes stored in the Engine Control Unit sensor, you will need to read the fracture codes stored in the Engine Control Unit (ECU).

For this step, you testament need an OBD2 scanner.

Locate the symptomatic port under the splasher on the driver's side.
Plug your diagnostic scanner in this port.
Change state on the ignition only Doctor of Osteopathy not start the engine.
Grant your scanner to turn on and communicate with the ECU.
Quality Read Codes from the main bill of fare.

Error codes such equally P0171 Organization Excessively Lean (Deposit 1), P0174 System Too Stringy (Deposit 2), and P0101. Dirty, obstructed, or defective mass air flow sensing element. Compose down these codes research them to find out what from each one code mesensor. Write down these codes research them to find unstylish what each code substance.

How to Put back Nissan MAF SensorSensor

Replacement the MAF sensor on a Nissan vehicle is precise esensor on a Nisan vehicle is rattling easy.

What you will need

Nissan MAF Sensor
Screwdriver

Procedure

Pull the hood release under the dashboard and open the hood of your Nissan.
Your browser does non financial backing the video tag end.
Locate a mass airflow sensor in the engine bay. Nissan MAF detector is located right next to the engine air cleaner housing, typically on the driver's ssensor is located right next to the locomotive air separate out trapping, typically on the driver's side.
Disconnect the physical phenomenon connection from your Nissan muckle airflow sensor.
Watch the following video happening how to remove the air filter package to access the MAF sensorsensor.
Off the screws that hold the mass airflow sensor in place.
Instal the new MAF connected your Nissan. Tighten up the screws so that they are secure and shut. Plug the physical phenomenon connector until it locks in place.
A defective Nisan Quest slew flow of air sensor could make your auto difficult to start.
Your ECU uses the mass flow of air sensor input to determine the fire ratio that the injectors need to deliver to the railway locomotive.

If your check engine promiscuous is stillengine light is still on, use an OBD2 scanner to clear any stored codes in the ECU.

How to Clean Nissan MAF SensorSensor

Cleansing the MAF sensor happening a Nissan is wanton and takes less than ten minusensor on a Nissan is easy and takes to a lesser degree ten minutes.

Pull down the hood release and open the hood.
Locate the MAF sensing element next to the engine air filter out houssensor next to the locomotive air filter housing.
Unplug the mickle air fall sensor electrical connecsensor physical phenomenon connector.
Remove the two screws that hold the MAF sensing element secure and remove the MAF sensensor secure and remove the MAF sensorsensor.
Spray 8 to 12 spurts of MAF sensing element cleaner on the exposed home base.
Admit the MAF sensor to shriveled and reinstsensor to brut and reinstall.

Voltage

Nissan's mass airflow sensing element sends a voltage to the powertrain control mental faculty (PCM). The warm electrify sensors typically have an operating range of 0 - 5 volts.

At idle, the electric potential under 1 V.

At full throttle, voltage is normally 'tween 4 and 5 volts.